Take an impression with moulding putty

Important Notes:

1. For best results for children,  soak the finger in warm water for about 1 minute. Dry well.
   
2. Apply approx 4cm of catalyst gel. (If more gel is applied than required, the putty will set faster. )
   
3. You need to work quickly once the pink catalyst gel has been applied.
   
4. You have approx 1 minute before it will start to set.
5. Make sure that the gel and the putty is mixed until there are no visible streaks
6. When pressing the finger into the putty, DO NOT press all the way to the bottom . Try to press about half way so you get a good print
7. Allow the mould to set for approx 5 minutes before touching.
   

Take an impression using the inkless wipe system

Important Notes:

1. For best results for children,  soak the finger in warm water for about 1 minute. Dry well.
   
2. Lightly Wipe the finger to be printed ensuring the whole finger pad is covered evenly
3. Place the coated paper on a hard surface
   
4. Less pressure equals better definition.
5. Continue to take as many impressions as possible. I will then choose which one to use when I receive it back
6. You can use both sides of the paper. Maybe do a hand print if you want.